Is it different than the old wires?

When you get ready to sell that Supercat make sure you put an ad in the classifieds here.

Woofman, please go check it out to satisfy our collective curiosity. Apparently this boat has been listed a few times and this time at least it didn'...

Upon further review....apparently as stated earlier in this thread (thank you leebow) the I.d. of the compression tube is 5/8 and this jibes with Murr...

Thanks everyone for the quick replies!! Sometimes this place is silent for days but not this time! Here's my plan of attack... I don't mind buying...

I think so....so if it's stuck, it's REALLLY stuck

The -14, the mono-cat, and the Vanguard 15 are all cake...as long as you don't forget the pin when dropping the -14 mast!

Just to chime in about the Supercat mast, and my experience is possibly a bit different. I have had a SC 15 (shorter mast, same section) and a Nacra ...

Well for me,I put it in the middle and forget it. There are many more areas of improvement in my sailing to worry about than this one. After I get m...

I tried the lifting it straight up method in the backyard with the boat sitting on the ground. It's way too wobbly for me to be comfortable doing it ...

$1000 is just the opening bid, could go higher, or much higher. In some states trailers don't require any registration at all. Hopefully a bill of s...

I got the link kit. The base was compatible. It required drilling the mast foot(?). Works really well as long as you remember to put the pin in!Edi...

Since we have members scattered all over the planet, I'd reach out for a third party that could inspect the boat for you. I did this with my last boa...

Take off all the hardware; gudgeons, eye straps, everything

Looks like a 5.2 and looks like all the big stuff is there

I only have two, I'm adding

Damon, I haven't looked today but the crossbar is marked port and starboard. I'm not sure, but I really think the port side is on the port side so th...

Well I'll still check mine. I need to replace the bolt anyway but I dont want to go through the hassle others have had with it being frozen. Next ti...

I never knew about the pre-bend. The manual I have references tension (it says the DS shouldn't move more than 1/4 inch) but I didn't see anything ab...

Damon, please close this thread.....

Thanks, I found plenty of info after searching the web

I drilled and tapped to one size larger on my Nacra. It worked very well. Other use heli-coils with good results.Edited by tnell on Jun 26, 2017 - 0...