Bob's a local cat sailing legend. Gettin near 70 now or maybe over haha, but still out there battling and occasionally pitchpoling having a great tim...

I installed these on my Prindle 19. They’ve been working with no leaks. I placed the hinge towards the back thinking I’d have easier access while on ...

Plastic vs metal The original on my P19 is still gong strong. Virtually no wear.

Solo windy choppy max boat speed 18.6knots

Go herebr /> Do not view on mobile device or you will not see the entire worksheet. View on computer. Compare the luff lengths to see which boats matc...

Take a look at the SCHRS ratings page. You can check out jib area and luff length of other cats.

I use my wife's blow dryer on low loosely gorilla taped to the drain plug hole (not completely covered). Unscrew the inspection port cap so its loose...

The P19 ticks off the list as JohnES posted. I owned a P18 for about 18 months but wanted something higher performing and moved to the P19 which I've...

dyneema works well

It looks like the delrin spacer is larger diameter than needed forcing the line closer to the edge of the plate. Putting a heavy radius in each corne...

The 20 second video says it all. Keep the 460!! Can you head straight for the ramp and round up the last 15-20 feet, jumping off the lee hull with y...

Is it possible to redrill a new hole forward of the broken one. Another option is to add a stainless steel doubler fastened and glued to the casting.

I've made similar holes on my Prindle for a righting bar attachment point. My guess is the bending loads in the crossbar are greatly reduced by the do...

Gorilla glue will expand with moisture and help lock the ball tight to the threads. Just make sure both surfaces are wet before applying. i use it ...

Great to see the lake has water!! See you at Tri-Point

I love sailing my P19 in rough conditions. It weights only 10 more pounds than the P18 and its hulls are much better at wave piercing. Choppy conditi...

Ventura Marina has a nice sandy beach area where you can setup for the day near the harbor entrance for quick access to the open ocean. It's a five m...

Bring your Wave up to Ventura sometime.

I'm out in Ventura most Saturdays as is Bob and his Dart.

Ha ,I'm a night owl and had to be at work by 6:30. Winds look good after 12 but I'll leave sooner if pos. Three boats total, bob solo. Plan on a 2 1/2...

Did final checks today. Motor mount and motor work well. New/old Dacron sail with H16 battens worked well. Centerboard box leaks have been mostly e...

Yep, I'm taking the P19. Should we bring something to slide the hulls above the high tide line? Bill Matson is still making crossings to the local C...

I just bought a used 2hp motor for the trip...now for the mount. Precious few weekends left to prep the boat and trailer, working way too much these ...

I just booked our second site. I believe we have three boats going and Dartman a maybe.

I've owned and destroyed two Go Pros by careless handling in wet environments. In the second incident, I used the open back to allow sound to get thr...

I'm in, but debating bringing a motor. If it's dead like last time, I'll probably turn back and save myself from another 12 hour crossing. I plan on...

I made one by riveting two SS right angle tangs behind the dolphin striker as emmettv suggests. The pole was an 1/8" wall 1" square aluminum tube 606...

Great hope to be there