Don't F18s have trap wires. I have seen people disconnect the bungee and hand the wire to someone on a safety boat and they pull on the trap wire to...

Ok I get this when I click the link This video contains content from EMI, who has blocked it in your country on copyright grounds. Sorry about that.Ed...

Try a sign shop. They have vinyl tape in rolls that are about 8 inches wide. A little tapping on their computer and you will have 4 stripes on a ro...

There are two nacra manuals here The one on the left has the 5.7 Also if you look through the photo albums you might find what you wanted to know an...

My MacGregor 36 cat had stainless bolts with stainless nuts that had the nylock inserts to hold the standing rigging.

I take the trailer winch strap and wrap it twice around the mast just before the rear beam. Crew cranks winch I pull up on the mast to get it off th...

Here is a thread about inspection ports in front of the beam.

jmoritz here is how nacraman57 made beam caps nacraman57 wrote: Guys, here's what I did with my 5.0....(5.0, 5.2, 6.0...all crossbeams are the sam...

Somebody has the wrong sail number

Take a small bolt with a o ring and thread it in to the mast just above the base. Totally seal the mast. If you ever turtled and some water gets in ...

Here is the assembly manual click on each page for larger.

After loosing a port cover "they sink" I sprayed great stuf foam on the inside of the lid. Once it had expanded and dried I took a hacksaw and cut ...

You can buy these already made $25.00 this one $18.50 They can be found here with more accessories Edited by skarr1 on Jun 26, 2011 - 09:22 AM.

Mine works, but I had to re-enter itEdited by skarr1 on Jun 24, 2011 - 12:19 PM.

Push them back square and follow directions here Edited by skarr1 on Jun 23, 2011 - 09:12 PM.

Here is a thread from 2008

Randy Smith has a trimaran that he calls Scizzor. The amas will move like you describe. 168 lbs total weight 20' long with 20" sprit, modified A-ca...

The wire should end about a foot and a half above the deck. The ring should be able to be stretched down to the deck. The bungee will keep tension...

Cats don't like to run before the wind. Start on a beam reach and get your speed up, turn down wind till you are on a borad reach to real wind. Your...

Did you see this 16 for sale on this site

Key Sailing is a Hobie dealer in Pensacola Beach. I have had good dealings with Schurr Sails in Pensacola. If you are going to race at Hobie Ca...

OSYC has some photos up here.

You don't set the ball hight, you set the load on the bar under the rod. I think you tighten the bottom nut till the main beam has about a 3/8 inch ...

Big Lagoon State Park. These photos were taken while sailing out of Big Lagoon State Park. 50 feet from the boat ramp Edited by skarr1 on May 30, 2...

Catamaran ID is in one of the photo albums at the top of the page.Edited by skarr1 on May 26, 2011 - 12:45 PM.

From the 5.2 manual Click the photo to read. Edited by skarr1 on May 19, 2011 - 01:16 PM.