Should work now Edited by rungi on Aug 26, 2021 - 10:28 PM.

docking post need to be alone so boat can so spin around it when the waves and winds change direction. same with an anchor. I have tried skiffs up f...

i think the 1990 nacra 5.0 has this type of rudder why do you want the flat one?

that is what I wanted to hear thank you

I see why the washers are there. They make keep the shackle tight. I think they are a very good idea. Also keeps the clanking down.

Does the one like mine hit the bottom if the trim screw is out?

I do have both the manuals. Do you think they washers are needed on the shackle as you can see in the photo of my mast rigging?

Ok thank you. I have it set up correctly. The jib rolls up in a second and releases in a second. The rigging in the picture is what I am using minus...

The rudder works perfectly. It just needs trim screws. What is wrong with it?

Here are two pictures one shows the rudder with broken trim screw not hitting the bottom of the boat the other shows the rudder without a trim screw h...

Any idea the purpose of the eye strap? Should only one side stay be loose (pin to the top of chain plate)when stepping the mast. I can attached the f...

Thanks Can you define bow tangs?

You see the little bracket attached to the mast by the swivel a few cm lower on the mast? What is the purpose of it? Can the forestay be connected t...

you think a rubber stopper or cork could be used?

delrin screws custom made? how did you that? or is that a stupid question?

All make an album later since users cant' post images directly to the forum. 🙄 The rudder definitely hits the bottom if the trim screw is no tou...

Thanks for all the help. One more thing. The pintles have to be inserted through the bottom of the gudgeons to attach the cheek assembly. Are spacer ...

Thank you very much for your reply. that is exactly what I was looking for 🙂

Thanks. Anyone know if good new stock bungee cause the rudders to go up and stay up when the rope is not cleated to hold the rudders down? My bungees...

Hey PM I see you have made 803 post and you make a statement like this: "There is tons of information specifically on the factory set up of the lega...

Can you please provide links directly to question? After stating there is tons of information on the subject, You provide a link to unrelated subjec...

So it the 5.8 mast 30 cm longer than the 5.0?

When I did go out yesterday. I could barley hold the tiller. I did not have the jib up and was wondering if that was the reason. Anyone every had the ...

I am looking for images and directions to install and setup nacra 5.7 rudders and tiller. Please do not refer to the manual. The pictures cannot be s...

no experts on these boats? also anyone how the 5.8 and 5.7 mast differ?

Ok Thanks, I am not sure the age of the ball I just got the boat. Do you know if the 5.7 sail work on a 5.8 mast? Does a new ball just screw on to t...