thanks, for some reason I always forget about that 4000 pg book colectn' dust on my book shelf.

what im lookn' for is best described as a 2"wide x10"long rubber peice of channel shaped like this [ ,its not a "roller" just a pad or buffer secured...

Im cuting the rusted rear beam off my trailer & adding some expanded metal to make a deck platform to store campn goodies under the cat, maybe a place...

wish we could all sail the same water instead of the cyber water!I dont care if its cold out I wanna go sailln Guess its time for a road trip.

maybe renting a cat for a day,or enlist a guide for a lesson& general whats up.

I chose the coated shroud wires w/ hydraulic swaged shrouds. I couldnt find any thing wrong with my old riggn but the peace of mind is worth the price...

main sheet tention can slow down the traveler from raceing to the other side alittle but you really should have one hand on the sheets puttn them wher...

next time I set set up, every thing is gettn a good coat of sail coat& ill look closer at the steppn hinge I think last time I looked at it it was a l...

any thing spring loaded sounds like itll launch out of site if not carfully handled,just my opinion guess Ive rebuilt to many carburators in my time!

coastrat has the instruction you need.for about a week I was refering to his photos& product advise .the west system worked awesome the pumps made thi...

MaceThebeachcats also has a classified section you might find a good used hull for sale.

use pad locks instead of shackles :-P.or show up an hour earlier.quick pins & shackles will help w/all but the shroud&forstay connections.down side to...

you can use sheaves as a spacer like coastrat "nice rudders by the way".upper & lower sheaves look to be the same,that is probably why murrays doesnt ...

I recently parted out a cat from craigs list.that sailed across the parkn lot by the boat dock,ground thru port hull snapped rudder out of transom, be...

I trailer my p-16 w/rudders attached,I only drive 10 miles to lake on nice smooth road so your situation could be different.raise your rudders all the...

the idea of having two plastic washers is so they slip on each other instead of your rudders & castings while takn up slop,but a nice smooth stainless...

on my p-16 I found proper rake&shimming my rudders weakened mylock down possition soI removed the bolt & springs bought the correct round rat tail fil...

I had a large soft area on the port hull of my p-16,luckily it could all be reached from inside, thanks to the access hole on the deck.I injected over...

posted some pics on members page "bills prindle 16".I can get to the soft spot in starboard hull thru access hole,the blisters are on the inside.do I ...

Thanks to all for some quick instite.It would be nice if the waves are a result of a sloppy mold,they appear pretty solid except for the soft de-lam a...