Here's what Hobie recomends 5/16" or 8mm runs faster and more free on the main. I know some guys that use 1/4" on the jib. Stay with New England's ...

Picture? I'm lost with your description. Taper the line then tape it so you have a point that progresses to the full diameter?

Also found them on Ebay, PacificMarine360 is the seller out of Washington.

Saw this on ebay, may be just what you need.

Don't know about those but Chuck and I both use the Murray's nacra rudder covers. Mine have spent more time in the box than in the sun over the last 7...

tamumpower1 wrote: Well I am in , We will be sailing a Hobie 21SE at both events..... 😎 Now to figure out lodging.....or camping is good for me. ...

dmgbear55 wrote: That book Catamaran Racing for the 90's must be good: They want a mere $483 for the very last copy. Unfortunately that amount of ...

Here you go.

Yes, registered for Juana's.

KurtHansen wrote: How do you attach the Cunningham and/or jib sheet to this shock cord? On the Infusion, there appears to be 2 lines through the bea...

Here you go.

Tuning the Nacra 6.0NA By JAMIE DIAMOND Where to start? We set up the boat according to Mark Biggers in the spring of 1994 when we bought the thin...

This is starting to get good. I need another beer and some more popcorn. I've never seen the Mystere 6.0 pitch but when the blades stopped humming, I...

I started off with a West Marine radio 20 years ago. I went thru 2 of them, replaced the battery every 2 years and the batteries were as much as the r...

howling_winds wrote: Any advice on repairing this? Do I have to take the beam off and apart to repair this? I took off the end cap but doesn't seem...

This is what I keep in my vest. Spyderco Saver Salt Marine Yellow Serrated Edge Knife

Looks like an early Mattson design for PWC Repellent Advanced Tactical Weaponry

If you do get stuck head to wind, remember push, push and pull, pull. Push the tiller and push the boom will back you up and put you back on the same...

Kenny, if you have a H18 cradle made up, take it down to the club and see how it fits on a 5.8, 6.0 or Hobie 20. I know you've got H20's down there. C...

Looks like an old 5.8 or 6.0 bottom to me. Hobie 20 cradles would probably work.Edited by nacra55 on Nov 11, 2015 - 05:01 AM.

Here's my thinking. That bow looks Nacra-ish not many boats have that straight blunt bow. I thought Matrix but the pics in the gallery show no boards...

That's not a Nacra stern. Not a Hobie deck. Not a Prindle bow. Got more pics? Is there a Hull ID number?

I don't quite follow you but maybe this will help.

Several of the N20 sailors along the Mississippi, Alabama, and Florida gulf coast use Schurr Sails in Pensacola. Also Check out Glaser sails.

leeboweffect wrote: I'm missing this bushing that the bungee goes around at the tiller connector: There's no bushing that I know of, at least not...

Edchris177 wrote: Ummm...Pete Begle or Dan Berger might be able to help, BUT, they need to know where you are, & what model of boat you broke. Come o...

yelkenli1 wrote: Does anyone have any recommendations for 'crutch padding'? I use a throwable life peserver on the back, and a cloth on the hard V i...