Since you are in Sarasota I assume you are mostly saltwater sailing which makes a big difference. They are often sold coated but not difficult to remo...

Thank you for your responses. I’ve decided to put sailing on hold for a few weeks till I can pickup an aluminum mast. Still can’t figure out how it ha...

Dogboy wrote: First question - are you sure the fiberglass is cracked? The outer surface of the comptip is a layer of resin that can develop cosmetic...

Still listed, I could really use those sails

I have a Gcat 5.7 and I removed the barberhauler system completely, it was just more parts for not a lot of benefit . I've just learned to live with t...

For simplicity sake, running rigging off a Hobie 18 will work, my jib sheet setup is off a Hobie 18, it is continuous. A Nacra 5.7 main halyard is a d...

Consider something like leaving from Hobie Beach in Miami to Key Largo, or Flamigo in the Everglades down to Islamorada, they are epic trips. As far ...

danielt1263 wrote: Green Key Rd is in Pasco and perfect launch spot for Durney Key Do you mean on the north side of the road, just east of the park or...

Green Key Rd is in Pasco and perfect launch spot for Durney Key

My Gcat 5.7 traveler is attached with machine screws, not sure if that was done by previous owner or if they just did certain years like that. Either ...

I was between Flamingo and Islamorada when Fwc took interest in my Gcat 5.7, he started asking for everything, then when he found no motor, no fishing...

I really don't like the Supercat 20 telescoping system. I would never consider going for a day sail with that setup. Tilt trailer makes life easier, b...

Chip from Whirlwind made me perfect jib for my Gcat 5.7 when I was on a tight time schedule for Everglades to Key West trip. Was reasonably priced and...

I don't know how I did it before cradles, so much more enjoyable.

Weren’t there 2 different mast bases on the 5.2, one style making it difficult to solo raise mast? I would guess that would add to setup time. I feel ...

It took me 6 months to get a furling jib for my 16 from another vendor, which they claimed was in stock. Its tough out there. Hope you get a hold of C...

Thank you, message sent

Thank you both, may use it as an excuse to upgraded to a less aged 16, but want to fix it properly for whoever inherits it

Have you found an Fx1? Not a lot in the states if that’s where you are. Not sure about parts, assume they are available but not sitting on your dealer...

Not much of an answer to your question but my Supersails 5.7 main has all same size battens, that’s how it came from them

It’s super easy to do but if you don’t want to do it don’t do it, these are pretty minor things that could be left alone but you asked how to fix them...

They are typically held with 2 screws and some silicone sealant. You will have to drill the heads off those rivets and see if it will come out, I don’...

You need to get the drain plug out and whatever all that white goop is to figure out what’s what. Not sure if previous owner made a mess with that goo...

Do you see any other places that have been repaired? Backyard boat repair can add some weight. I’m always hesitant to cut into stiff decks, sometimes ...

you maybe able to sail it pretty well with the boards up but there are times this will not work well i.e. if you get into upper air limits or just hea...

Somewhere between a Nacra 5.0 and an F16 is pretty much the whole spectrum. I wouldn't rule out a Hobie 16, best chance of finding one in your area in...