So the big question is does anybody KNOW? I would like to know the answer.

Will the smart time give you real time data, such as speed.

You guys have talked me into it. I need to get me a H21, I don't understand the rigging though, 3 hours to launch? My 5.2 is 25 minutes tops. Is it th...

Boy you know the season is over when that post gets 2 comments.

My winter project is too find the dang leak in my starboard hull. It has baffled me. Also move jib leads, restitch the tramp, remove the middle pipe, ...

Let me second coastrats expertise.

What is bedding your crossbeams

If it stays warm I am going Saturday (if I can find a crew)

ome have a galley, head, sleeping births, etc, Of course we recommend you go to the hospital for this

I love this site

You have the correct scenario. The rudder is bumping right below where it is riveted. I will try the steel rod thanks. It is a slight bow ( I had to p...

Erice I am impressed but the pintle is the rod that fits through the gudgeon. The tiller is depressed enough not to allow the rudder to go down fully....

The arm,

Never let the truth stand in the way of good humor.

Subaru used to come with a trunk monkey. I was foruanate to get a used one and it is really helpful.

Thanks Edchris177 wrote: Well it is one more thing for the the main, jib halyard, front shroud, trap line to wrap around. The hobie gets a plus, also...

Edchris177 wrote: GolfDad ,what are/were your concerns regarding the diamond wires being a PITA? Well it is one more thing for the the main, jib haly...

Yes the 5.2 is a more complicated boat to rig but by how much? The mast rotator and put two boards down. I will admit the diamond wires are a pain in...

Hey Jeremy nevermind I have one of those. 🙁 :wallbash:

averdunn if you don't want the nacra call me, I will buy it.

You could not have made that up. Boy when things go to pot they do in a hurry.

Hey are you going Saturady? What time?

Thanks found the hairline today.

Well wolfie if I ever sit on the the promotion board I will get you to admiral.

Your right, but I would not suggest using anything over 1000 grit uless you are planning on gel coating again.. Find a small flexible sanding block, D...