"is this english?" Perhaps this will take some of the mystery out of it.

Where are you located? You can determine length eye to eye with a couple of finish nails,a long enough board, and a tape measure. The last time I need...

I went with pressure treated 1/2 ply reinforced with PT 1x3. glued up with PL adhesive and fastened with SS screws. I painted the exterior with bed li...

This post is gone.

I think that member bought a H18. I wonder at the spec in the ad that says the 3hp motor moves the boat at 15-20 mph.

Math? Yeah, if you bear down hard you can abrade the anodizing.

A green pad doesn't remove the anodizing on my mast. Imron applicators use green pads to buff out flaws in their paint jobs. If you don't bear down to...

I run a green Scotch Brite pad up and down the track every so often. While the sail is still rolled spray the bolt rope with McLube. The advice on sl...

If the thimbles are too big the wire will stress coming out of the sleeve.This can create a break point. I've been dis-masted because of that. What...

It's in Northern VA, in Stafford County.

Same as my lead. This is about as close as you're going to get at the moment.

Have you seen this one?

Here's the response from David at Bloodred about USCG certification. Our Integra harness meets 50N ISO safety rating. i believe USCG standard is 75N ...

If it's a H21 SE you're in the market for check this one. check this site for Super Cat.Edited by gahamby on May 17, 2020 - 05:41 PM.

The other solution is to re-rig for a sliding goose neck and attach the tack right to the boom if there is open mast track.

Aquarius' factory downhaul rigging. Granted not the same setup as yours, but if you put a set of mast mounted blocks on either side of the track you c...

I asked the Spinlock rep about such a product at the Annapolis Boat Show.He didn't seem interested. Will the product linked above have USCG approval?

Is there a HIN on the transoms or stamped into the pylons?

I'm thinking Prindle.

Cool little cat! My SC15 doesn't rig mast rotation by design, so I'm talking through my hat here. In looking at your post over at Hobie, I would vote ...

check the pics of the Tornado in the classifieds on this site.

I got mine from SLO. It's been fine.

This listing is 2 years old but still there. Maybe it's still active. Even older! How about this? OOPS! Just the trailer.Edited by gahamby on Apr ...

I went with this: The wisdom seems to be to trim the main more with the traveler that with the sheet. Attached are the late Bill Roberts thoughts ...

I had a Coleman era H14T. No soft spots. It had the red hull to deck joint glue.

I have had that very experience while trapped out om a SC19. The pigtail above the roller furling swivel failed at the Nicopress eye that was shackled...

These guys are good. Not a source for sheet foam apparently. I have used this foam before, good stuff. No experience with this product. search air...

I use a telescoping mast support. I find it works well. I use the trap wires to stop the dreaded sway. I connect the head stay via the chain plates on...