When I sail I have to drive three and a half hours pulling my boat. I like to always think I am prepared so I keep two spare tires on the trailer at a...

I wish I would have found out about that place sooner. I just purchased my square top sail for a Nacra 6.0 from EP sails...........it was very over pr...

The water must be comeing from the bottom of the hull where the daggerboard goes. That took a hell of a hit if you broke your daggerboard. Flip the bo...

I know it is expensive 600 + dollars for a set, but it is worth it. Buy it new and then take care of it and it will last you a life time. Make sure to...

Just use a standard hand drill and drill a hole exactly in the center of the tube. Buy the yoke assembly from Murrays.com .....Item Number: 01-0062 .....

This is how I launch both my Hobie 18 and Nacra 20 in New Orleans from a standard boat launch. 1. First park the boat in the parking lot where you h...

I had a 1986 Hobie 18 and used to have fiberglass and switched to the aluminum pins. If you bought your supplies from Murray's, then the pin length sh...

You are right, you have two choices, either a righting pole or the water bag. The pole works well and is very easy to deploy because it is always conn...

Go tothey have a great article about how to lift a mast solo. You use a electric winch......easy to install and works perfect.