Alternatives A SuperCat towed by a SuperBird! A Mustang 5.0 pulling a Nacra 5.0 A Dart hauling a Dart.

Love it. A 96 Roadmaster with an LT1 would pull anything. Had a woodie Tornado for a few years, pretty boats.

I was thinking what was worn off is less than the size of a pencil. MN3 thanks for getting the picture put here.

Its worn through the gel coat, and appears small gaps are present. I guess i need to read about what gelcoat can do. All this epoxy/polyesyer resin/ ...

Sounds like just a layer of West is the way to go.

I put an image in my folder titled nacra trailer.

Yes, once the monsoon over the state of CT leaves.

make rigging your boat enjoyable Great approach. Rushing means mistakes happen.

Thanks, can't wait to try fhis out.

How long are the tubes? I install it before lowering the mast just above the shroud adjuster

To manage the standing rigging I have a couple tubes This is genius!!!! The wire management is my biggest nemesis. Is this rubber tube? Is it split?...

found using old Cordura satchels with 2 zippers pockets and the typical buckles (from conventions) work fantastic to manage cabling and buckle around ...

klozhald wrote: Yes 2 tires per pontoon Please call them hulls, not pontoons. We (you and I) are multihull sailors, not multipontoon sailors... Pont...

Hiw fast are the Capricorn F18s?

Thanks guys!

Dumb question: what is benefit of on tires vs on dry sand? Avoid sand blasting lower hull on windy days???

I havent used a righting board so not sure of how to operate it. If standing on it is required, i may need to custom make a beefy paddle.

Do you use two per hull?

I uploaded the CAD images to a folder called 'Nacra Trailer'.Edited by ctcataman on Mar 23, 2020 - 09:58 PM.

I will check out the Stilletto system. Its for the Nacra. I can raise it, but like the security of a gin pole set up. If i take care of my back now...

Andinista wrote: I though it was enough to be a child yourself... LOL

Good idras, thanks guys.