I adapted a tiller base fitting for that connector. The cross pinning hole should be small. I think a bushing was required, i turn one from delrin

Love drone footage of cats...thanks.

quick release truss clamps Cool idea, I love how fast these could make the load and unloading.

Let me see if I can find crew for the 11th.

Want to expand your fleet Pete? 😆

Thanks MN3

Vice is a good trick. I found the mcmaster thimbles are a tad too long. Cutting them back helped. I pre crimped the terminal end, put the thimble ove...

Found this on Bosun Supplies, good idea about the pre crimp. Nicopress fittings are wonderfully convenient, but can involve some wrestling during set...

Anyone have a good system for getting 1x19 to wrap around the thimble? I can get them just about right, but the transfer to the nicopress crimper, it ...

My jib sheet terminates at the becket on the block. New 1/4 line and maybe new bungees will make the rudders work better. Verify jam cleat is ok. The...

The thimbles that match the ones on the Nacra, prob factory, are 3/16 " light duty, mcmaster pn 8914T25. This is for 1/8 inch rigging., 1x19.

The self tacking conversion is still pending. Got caught up in too many higher priority projects. Probably biggest hurdle will be modifying an overlap...

Boomless Nacra are fun boats! Nsturally start on light wind days.

How is this repair holding up? It looks like the angle adjstment screw contact area gets easily crushed on these rudders. One of mine is a little sp...

Is the 'triangle' the dolphin striker?

I use a gin pole permanently attached to my traile Now that is cool! Do you have pictures of the full set up on the site?

I think my most appropriate time will be around 45 45 seems like a good target. How do you raise the mast on your 21?