So sad is there any consensus of what happened or is it just an unfortunate accident

I have 1/4 20 socket head set screws with rubber O-rings how about coating one with white lithium grease since I'm in freshwater only I was going to u...

Thx, MN3, did not know that about main, I'll make us a bridle. For the Hobie we'll have to bungee the jib

On our hobie we used a small die grinder with a thin cutoff wheel to make a screw driver slot in the broke off screw It put a slight groove in gelcoat...

[del][/del] Randy Smyth made my furling jibEdited by carl2 on Jun 12, 2019 - 03:03 PM.

same kit on mine Edited by carl2 on Jun 12, 2019 - 02:55 PM.

oops, double postEdited by carl2 on Jun 11, 2019 - 07:05 AM.

Are the pylons epoxied into the castings?Edited by carl2 on Jun 11, 2019 - 07:05 AM.

Thx, here's what I'm looking at br /> Edited by carl2 on Nov 05, 2018 - 10:46 AM.

my 19 needs bottom job, mind if I ask what it cost for the hull work, would'nt mind it if they got the whole treatment, I'll be discussing hull work w...

Yes, I replaced mine, We had to sand a few thousands off the bottom of the car to make it fit. Thought I purchased the wrong car but we didnt. Found o...

2 people, a rubber mallot, 2x4 block to remove hulls Same to install, obviously work each corner evenly as possible

br /> I did it using west system with filler to our 84 red line Worked out great & boat is tightEdited by carl2 on Oct 02, 2018 - 01:16 PM.

Thanks 😀

The 17 is 8.5, but I need a rich benefactor Length: 5.25m (17.2ft.) Width: 2.6m (8.5ft.) Main sail area: 17m² Jib surface: 4m² Gennaker surface (...

Length: 6.0m (20ft.) Width: 3.05m (10ft.) Mainsail area: 21m² Jib area: 5m Gennaker surface: 24m² Weight: 190kg (425lbs) Mast height: 10.36m (34...

I'd want a set of 19 hulls, Hobie did it for the 18's back in 09 or so. Sam made some good points about used boats for the same price as a set of hul...

I own an 86 19..what a fantastic boat, Its to bad about the molds. I love my Prindle.

Thx! will radius them and if line chaffs again in goes the 3/16 dyneema

Fwiw, I got the murrays kit for roller furler for prindle 19 Came with pigtail. Bought a furling jib from Randy Smyth with vertical battens..see my p...

hmmm nher207... is a registered user here.. 😀 User name: nher207 Time zone: (GMT -5:00 hours) Eastern Time (US & Canada), Bogota, Lima, Quito...

True that but my rig hauled a 10,000 lb race trailer with 10% of that in tongue weight, My nacra or my prindle are not gonna touch that., even with th...

I actually made a 4 FT extended ball mount for the receiver on my coach. A 40 ft MCI 8 Works great.

pics taken with my galaxy s5 are upside down.. or sideways & break when rotating. whats weird is it is not consistent. Some are ok :roll:Edited by ca...