Supercats don't turtle.

Which step in process is causing the issue? Climb up the tramp, pull the pin, open the lever then pull the second pin if needed. Bill Roberts claime...

There are used rudders and sets around. Probably some here in the classifieds or FB Marketplace, Offerup, etc. Any Rudder from a SC15, SC17 SC19 or SC...

Lot's of lakes in the Ocala area that are sailable, some have clubs. You can drive on both Daytona and New Smyrna beaches and launch, but that's a hik...

Bitchin

I don’t know how or why my above post came through as guest. Can you expand on “Nader”?

Couple more pics and once I got everything stripped of got a final measurement of 32'6". The mast hinge has the company in the casting of Internationa...

I found some pics of older (original) tornado masts. It appears to be one of some vintage. Here's my pics.

I'm fastidious

There are also a handful of places to pull off and launch if you head south on Hutchinson Island towards Jensen Beach.

The Stuart Causeway, far east side of last bridge before you get on the island. Post if you go, I'll be there if in town.

That didn't last long. Any idea what happened?

I think I'm all set with two, but maybe a third is better. There sure are some interesting upgrades.

These are a must:

n fact, looking at the hulls, it's hard to see how the boat sails well without boards, but apparently it does. 17 and 19 are the same hull design. 17...

waterman623 wrote: Great to see another SC getting back on the water. Tom and crew are great. Any idea what year the 19 is? The hulls are numbered 1...

waterman623 wrote: Great to see another SC getting back on the water. Tom and crew are great. Any idea what year the 19 is? The hulls are numbered 1...

Great to see another SC getting back on the water. Tom and crew are great. Any idea what year the 19 is?

Supercat 17, Jupiter FL.

Both of my SC17 masts have the hook at the bottom of the sail track. It works well and is easy.

I'd go with a Getaway and get the wings. I've had 6+ on one and been fine, you're not going to rip trough the water they still go.

Got out for a good sail today. Had my brother along with my boys and wife. Made 6-8 runs 10-15 knts with my bro and I on the boat, all good. Then I g...

Yeah, that's raked way back and I see the shroud extenders are hanging. Is that a gin pole or spin sprit?

My SC17 has a tiny, maybe 1/8" hole in the very top of both transoms. I never knew what is was there for but perhaps it's a vent.

Some SC20s were made with telescoping beams, so it is doable.Edited by SC19 on May 03, 2022 - 10:39 AM.

Look at a Getaway. Easy to sail and not over powered. They handle 4 people well and I had 8 people (mostly little kids) putting around.

Great vid!

I did a splice and sleeve on my mast. Pretty easy. I used screws instead of rivets at the advice of Tom at Aquarius Sails. He also suggested (highly) ...

I can't even sew a button on a shirt. Well done, mad skills.