That is perfectly normal Think about for a minute

Before you consider haggling you better consider what boat this Cheeta motor mount fits They are boat specific and are about $400 plus new It will not...

I would replace it with the newer version one with adjustable spreaders I think I have a couple lying around

Easiest way I found for securing the cat trax to the trailer Get a large Ubolt and secure the cat trax just forward of the boat to the trailer tounge...

Just another question If you are running at 60 plus MPH How fast do you think a 8 or 12 inch tire is traveling in comparison I have seen sailors tr...

Just another question If you are running at 60 plus MPH How fast do you think a 8 or 12 inch tire is traveling in comparison I have seen sailors tr...

The rudder casting are nacra The beams also appear to be nacra, not only in shape but the way they attach as well Very well good be a combination of d...

Newer boats had a half moon spacer that was bolted into the hull at the end of the beam to prevent movement

The center beam was used so that the front beam did not twist and stayed in position When not used most would drill and install SS rivets AT 10 and 2 ...

Would you have a pre cut kit for a 2005 Nacra f18 The 2005 has different size dagger boards They are approx 9 inches wide instead of 8 inches like mos...

I put the rubber on both sides of each board slot No more problems

nacra 5.o or 5.7 neither have a boom or dagger boards and are great boats Newer versions are 500 or 570

Remove the front end cap and look inside to see if is sleeved. It will start about an inch or so from the end and go to a little past where the dolphi...

I live in Delray Beach and owned a Nacra 6.0 for many years. Would be glad to help Send an email to Hullflyer1@netzero.com

In addition to uncleating jib, main traveler and main sheet also release the down haul all the way. If left cleated it forms a huge draft in the mains...

have one located in south florida

I meant to say that no Prindle 15 left the factory with a jib

They just added one No Prindle came from the factory with a jib it was not designed to have one

The Prindle 15 was designed for single handed sailing Mainsail only no jib

To spags The Prindle 15 is a cat rigged boat (Only a mainsail no jib) So there is no pigtail Some have added a jib and rigged it all different ways Ea...

Just replace the most bottom clevis pin on the shroud attachment with a bow shackle and attach the wire jib pigtail to the shackle, you could also use...

Does it have multi places for the mainsheet blocks to attach or does it have an adjustable boomlet on the clew of the main If so the further forward y...

Sailed one for 10 plus years, it is a great boat. Can handle the rough seas and wind. This boat can reach like no other cat that I have sailed.

I have posted this before and it bears repeating I would advise against using factory wires or after market wires for many boats. Some manufactures ha...

Easiest fix is to file stops so they are flat and at 90 degrees and then get a piece of SS the same size drill a hole in the center of the piece and s...

The earlier 5.8s had the halyard coming out of the mast track a few feet up the mast I never had that issue Can you take a round file and clean up any...

Beware of cheap Asian SS wires

I the holes are only about an inch or so from the bottom, remove the mast base and cut just above the holes and replace mast base.