Paint the tires whiteDogboy wrote: Exchange scratches for black marks? Perhaps a little better load distribution to prevent point loading the hull. ...

If the horse is dead, get off!

Although EPO rudders are better, the plastic versions have lasted 20 plus years on most boats. I would assume that new ones would last at least that l...

NADA 1987 P 18/2 $1500-1700 with trailer The closest to 1985, not sure if the were made earlier, shows as 1987 was the first year Performance Cat was ...

NADA used prices 2000 P18/2 $3300-3700 2003 P18/2 $$3700-4200 2004 P18/2 $3900-4400 I think this is the last year made All these prices are with a tra...

WHAT YEAR IS THE BOAT?

Mast will fit P18 or P 18/2 Wings are desirable Beams will fit P18/2 or P19 Tramp 18/2 Boom 18/2 or P19 Main sheet block and jib blocks multiple boat...

I owned a Supercat 20 in the early 90s and used ballon style tires from cat trax and used an extra long axle with cradles. I used 4 tires, one each on...

Re read the ad If you want the wings he wants an additional $800, that put the boat over $6,000

Hobie Getaway masts separate into 2 pieces so trailering on a flatbed should not be an issue

It's a 42 year old boat

Go for it! Don't listen to those who are afraid of a challenge. I have been sailing beach cats since 1975 and I am now 75 years old and still sail. So...

I believe the hole in the end cap is for the shock cord for the trapeze, not the righting line.

Guessing the weight of the extra 2 on board the fox at 300 to 350 pounds. Put 8- 45 pound free weight plates (the kind you see in the gym) on your bo...

The boat will point higher with no jib One reason for the jib only going to the front beam is the new boats have a self tacking jib

After you fold it to the 2nd or 3rd batten and start rolling just make sure that the next batten is in line with the roll. You do not want part of a b...

Sounds like you are rolling it from the bottom to the top as it comes down. It is always best to drop the sail all the way down and roll from the top ...

In the past we used to use shock cord when I did a lot of racing and it was important to keep the tramp super tight. We did it to protect the grommets...

Have you considered a WETA

Is the tramp forward and aft as tight as humanly possible. Hobie sells a tool for tightening tramps. Looks like a T with a fork at the bottom so you c...

Drill out the rivet at the front of the mast at the base. Let the water drain out and replace with a self tapping SS screw and seal. Then make sure al...

The Nacra 6.0 NA had a Jib uphaul with a roller furling jib

Has anyone else had these issues? Sent an email to Damon

you can also remove the head and base if it is needed if the corner to corner is close

what is the measurement corner to corner of the shipping container

If you go from a non adjustable to an adjustable you will have to drill a new hole for it to work properly. Maybe go to the Hobie 16 forum on the Hobi...