tominpa wrote: I think the line size is the largest that won't foul in the rudder casting and is in like-new condition. The teeth in the cleat have j...

Also check the size line you are using. On the beach pull the line as if the rudder was kicking up and see how much it moves. If the right size it sho...

remedy wrote: Why register the boat and pay taxes/fees if the state doesn't require it? Hey Tim, the reason is that any vessel over 16 is now legal...

I have a nacra 5.7 mast for sale, also a tramp and a rear crossbar. Located in Delray Beach Fl 33444

cloudchsr wrote: Anybody try it? I've got a yard full of beach cats, and the old 18-2 is still competitive with pretty much anything, but the spinnak...

Why don't you post it on the classified ads section of this site with pictures and a price?

stufish wrote: Hi, new to the forum. Where can I store my Nacra 5.8 close to the water so I don't have to tear down the mast everytime I use it? Whe...

Seadek is a great product for non skid and protection. Very easy to install

get in touch with Aquarius Sails 651 462 7245 They are the SuperCat company

If it is to long it could cause the mast base to break where the clevis pin goes through when lowering the mast.

No one mentioned one of the most important factors. How your sails are set when you launch from the beach. Also how to just trail your rudders when la...

A Getaway is a recreational boat A Prindle 18./2 is a performance boat Big difference

Murrays

The Hobie Getawy can carry 1000 pounds close to 450kg

I have always used a straight claw hammer, putting the claw between the tire and rim and moving the hammer side to side. It has always worked to break...

Solid aluminum mast is much better than a comptip mast. I would change even if the comptip was not broken.

Same with the booms, the one in front is Hobie

In the top picture the one in front is a Hobie gooseneck, the one in the back is not.

rch701 wrote: I am hunting for a spin for my 5.2. I have a windsurfer mast already and mocked up the boat to pull a tape measure. Mid-way from the hou...

You could also support your local Hobie dealer. People complain when they are no longer around, yes you can go to the internet, but when you find out...

There has been quite a a bit of side pressure to the bolts over time making the bar difficult to remove

normally there are 2 bolts on each end and they are welded to a plate on the inside of the beam, not welded to the beam just the bolts welded to the p...

If it has a slight angle forward, it may have been towed to the beach or on to a trailer using the dolphin striker rod which should never be done. Sho...

You can call me at 5613051349 and I can explain everything. I was a Prindle dealer in the 80s.scotth wrote: I'm completely new to cats, I've sailed on...

Sorry I forgot to also mention that the P16 jib was like the H16 jib with a wire forestay in the luff. When Prindle made the changes above they also w...

A very easy explanation. In the mid 70s to early 80s (not sure of the year they changed) Prindle used the same system as the past and current Hobie 16...

Just post a new ad on this site. Its pretty easy!

In 1994 there were no F18s only Nacra 5.5s which were 18 feet and not similar in any other way. Hulls different Rudders different Rudder castings diff...

Coleman also took over Harley Davidson from some time and it did not go well. The saying was you needed 2 bikes, one for spare parts. Fluid leaks were...