H16 with comp tip, EPO gen 1 rudders, furling jib my son doesn't race so it's all good. This boat is an older model but it takes anything Lake Ontario...

here's a link to the trac 16 manual. hope it helps.

hey popeyez7, i sent ya an e-mail with contact info if ya get a chance next week have a safe trip up here and bergen is a nice little town.........

Hey popeyez7, yer right on flt 204s home grounds. ever sail with them? Check out our 34th annual regatta on the regatta calender Aug 3-5 at Hamlin Bea...

This is what my son uses on his H16. He's on his second one, got about 9 yrs on the last one.

Quarath, for your plugs try McMaster-Carr. Here's a link if you are looking for push in plastic pugs. I used these on an outboard motor stand and they...

Hi Tom, If the overall condition of the trailer is good, then you might consider an etching primer under your topcoat, such as POR15. see link. Of cou...

One of our club members was out for a couple hours on Lake Ontario last Saturday, Dec 3. Then we knocked his boat down for the winter. I've been out T...

If you can afford them, these are great. A friend had them on his H18 and then his Mystere and they worked awesome on both.

Thanx for the comments John. I'll answer your questions and offer any thoughts if you build another set. The spacer is G10 or similar material. Just ...

Link to tech help album br />Edited by CatsailorMike on Oct 01, 2011 - 09:28 AM.

I made a short album and put it on Photo Albums, Catamaran Technical Tips. couldn't figure out how to get it on Technical Help. If anyone wants more i...

Two guys in our club have them and the are both real nice.

hey riverrat cmon up to the rohrbach ontario hobie regatta this weekend aug 5-7 at hamlin beach state park, we usually have a good 17 turnout. racin ...

I tried to add to calendar but not sure if it made it. I'll check later. Thanx Damon

I've looked here, and I don't see anything that would be what you're looking for. Also might checkthey may have something. Might be easier and safer ...

try these guys too. a few boats where I am have had good luck.

on e-bay in norfolk, va

try pettit easypoxy polyurethane. available at west marine. i'v used it alot and it's great. gives a super smooth finish.

try these guys. a friend got sc20 beach wheels from them. they should be able to help.

mix up some west systems epoxy according to directions and add west systems 406 Colloidal Silica filler until consistency of catsup. tape up one side ...

check this page out. has tubes( round and square) and u channels. my pick would be round to slide over the up rights.

check mcmaster-carr.com they have anything

there is an aluminum plate glassed into the inside of the transom.

if you are talking about the rudder gudgeons, there should be an aluminum plate glassed in to the inside of the transom.

they're 1/4" stainless steel

here's one of our fleet members. he said it was a rush!

If you're going to be in Niagara Falls check out this place. They should have something for ya. Obersheimer Sailor Supply ?1884 Niagara St. ? Buffalo...