Inside the crossbar is a plug with threads. It is riveted from the outside to the inside of the crossbar. You need to remove the the end cap of the ...

Check out www.hobiecat.comau/pdf/support/rudderdrill.pdf

SOLD

Just a note. These sails are over $1700 new! Also, I will throw in a sail bag with purchase

LAST REDUCTION $1000

OK, no bites, Lets try $1100. Nationals are coming surely some could use a new set to be competitive.

I won a pair as a prize at a regatta 2 yrs ago. Had just a coupon with contact info, called them, got right thru and they sent them out right away no...

I have a H18 and camp on islands in the intercostal Clearwater area. Weather can change real nasty in a hurry. I use a bridal ste up off the bow tan...

ADDICTION It's a legal one!

Hotel reservations made, hope there is an 18 fleet since I am coming from Florida.

You have to take the end cap off. The rollers might need replacing also. I have had to rebuild mine a few times over the last 20 some years. You go...

Still have not heard from anyone. I am planning on coming, any other 18's out there planning on attending? I would hate to drive all the way from Fl...

I am in the Tampa Bay area. I have tried to pre-reg. with rick and mark with no reply. I am coming, hope there will be an 18 fleet? Jim.

Hey! We need at least three more 18's

Dito on the SNU_SNUFFER. Got one for my Hobie 18 and love it. Als got a cover with it for protection.

Agree with above, coil wires seperately and bungee to tramp. Figure up a set up routine and do it the EXACT same way each time and just reverse the o...

I use the "UPTIGHT TRAMP TOOL" from Murrays. Works like a champ. Hand tighten all sections first, the use tool with a little bit of force once then ...

Catley has been there since last Saturday. I took 4 tents there Sunday. Took rest of the gear out the today via power boat, Going in the morning wi...

Wax the entire hull. Some of the big boy racers sand their hulls before each race but wax will keep them looking good.

I can see I can see!!! You are doing a great job with this forum by the way. Thanks for all your hard work. Jim.

The humming is from the rudders. Take a sharp pair of scissors and go over the trailing edge on both sides of the rudders. Open the scissors and scr...

Andrew. Plan on sailing this weekend. Thanks for the congrats. The actual regatta was Hobie Midwinters East Coast Championships. Needed to correct...

Andrew. That is , jgraves2@tampabay.rr.com sorry

Andrew here is mt e-mail address. What is your phone #? jgraves22tampabay.rr.com

Andrew, Jim here. My new yellow tramp is from SloSail. I love it. Got the teflon stitching upgrade. First tramp was a little wide, contacted them,...